This setup is a custom build: a stock cage with a few swapped parts, coated in coloured UV resin.
The parts
- Cage: the mini keyless pot lid cage (DKZC-020) from ifrrk.
- Base ring: a curved base ring (K05), also from ifrrk. The cage only comes with a flat ring, so the curved one is a separate order. It fits ifrrk cages that use the hex key lock.
- Screw: a 10mm hex screw in place of the one the cage comes with.
- Spacer: usually a metal machine nut. It gives more room, so nothing kinks when you pee.
The resin coat
The cage is dipped in, or coated with, clear UV resin. Mica powder mixed into the resin gives it colour, so the look can change from coat to coat. Plain stainless steel gets boring.
The coat also smooths out the crevices inside the cage. Those crevices create negative pressure against the skin, which causes blisters. For a fix you can rework, fill them with beeswax instead.
Bored of the colour? Soak the cage in isopropyl alcohol for a couple of days and the old coat peels off. Then dip it again.
UV resin works on metal cages. For plastic ones, use beeswax.
Skip spray-on sealants. It’s not clear how body-safe they are, and the skin there is thin and absorbent, so anything you coat a cage with has to be.
More detail
There is a little more about this setup in this Reddit comment. Questions about it are welcome in the Telegram group.
The ifrrk links are affiliate links. If you buy through them, the group gets a small commission at no extra cost to you.